Another B13 rear STB

[Josh Palmer]

I modified Omer Khan's B13 rear strut tower brace design.
The bracket is very similar, but this design has a block
welded below the bracket, with a threaded hole low enough
so you don't have to cut any sheet metal.
This prototype is only spot welded in a few places, just
to check the fit.

Here is a link to some pictures:
http://www.geocities.com/jjpalmer314/b13rearstb.html

The brackets and blocks are steel because that was what
we had in stock. The center bar is aluminum, 1" hex.
I'll probably make another one with aluminum brackets
and blocks, to save weight. The center bar should be
rigid enough with a 7/8" hex bar - I'll probably make
one to test it.

If anyone is interested, I'll make them, at our cost,
which will depend on how many people are interested.

Josh Palmer
1993 SE-R
Materials Mgr / MIS Mgr / Estimator
Quality Machining Inc (www.qmiwi.com)
1001 Uniek Dr.
Waunakee, WI 53597
608.849.8057 Voice
608.849.8957 Fax