S3 Cams for roller SR20 " READY "

[mike kojima]

I already dynoed them, you are looking at 1-2 hp loss
below 3500 rpm with gains starting from there with a 9
hp peak gain right at the roller motors fuel cut.  If
the rev limit was higher, the gains would be even
better!

With adjustable timing gears and advancing both cams,
the bottom end and midrange would get better, but I
did not have time to experiment much other than I
advanced the inake cam 2 degress with good results.

Mike
--- Lee Combs <sr20depower@yahoo.com> wrote:
>  I would advise looking at a dyno before you sink
>  $560
>  or whatever into them. Without an ECU, you may be
>  limited to what you can do with the gain of the
>  cams.