Cv joints

[Matt McCrary]

raxles.

_________
matt mccrary

sent from my phone...

On Jul 14, 2011, at 23:39, RHS <helicoptermech at yahoo.com> wrote:

> Anyone out there replacing the entire front axle needs to be aware  
> of the poor quality of the aftermarket axles available. I recently  
> replaced both my front axles on my 96 200 sx se-r only to develop  
> oil leaks on both sides of the gearbox immediately after. Be aware  
> that in many cases these offshore companies machine the seal journal  
> during rebuild. It will look fine but it will be undersized and the  
> seals will no longer function. I had to replace both shafts AGAIN as  
> well as both seals. $440 later it stopped leaking. Measure the  
> journals when you remove your old shaft and measure the replacement  
> shaft before you attpt to install it. You should never buy the cheap  
> chineese shafts either. They are junk. Good luck to all.
>
> Sent from my iPhone
> +-- 
> --------------------------------------------------------------------+
> The mailing list home page is http://www.se-r-list.org/
> To modify your subscription, go to http://www.se-r-list.org/mailman/listinfo/se-r