Window Weld and Motormounts

[P at]

Not too long ago Joe P. wrote:

> McMaster Shore 94 A is harder
> than that, though, and would be my personal choice if I were to do it
> again

The two part mix from McMaster is great stuff, the nice thing is that its
pretty runny when you mix the components together and fills up all the voids
completely, just make sure to tape up the back side really well.  I found
the aluminium tape used for duct work to be perfect for this.

You can also get the stuff in different hardnesses, here are the partnumbers
at www.mcmastercarr.com  You will only need one small container to do all 4
mounts.

8644K18 for shore 94A
8644K11 for shore 80A
8644K24 for shore 60A

P@
www.customsteel.com
99' G20 with some mods....