detailed instructions on unsubbing

[David Pertuz]

In case anyone decides to unsubscribe themselves (and why would any of us want to do that??)

David


The proper way to Unsubscribe:

First, ask your Internet Provider to mail you an Unsubscribing Kit. Then
follow these directions.

The kit will most likely be the standard no-fault type. Depending on
requirements, System A and/or System B can be used. When operating
System A, depress lever and a plastic dalkron unsubscriber will be
dispensed through the slot immediately underneath. When you have
fastened the adhesive lip, attach connection marked by the large "X"
outlet hose. Twist the silver- coloured ring one inch below the
connection point until you feel it lock.

The kit is now ready for use. The Cin-Eliminator is activated by the
small switch on the lip. When securing, twist the ring back to its
initial condition, so that the two orange lines meet. Disconnect. Place
the dalkron unsubscriber in the vacuum receptacle to the rear. Activate
by pressing the blue button.

The controls for System B are located on the opposite side. The red
release switch places the Cin-Eliminator into position; it can be
adjusted manually up or down by pressing the blue manual release button.
The opening is self- adjusting. To secure after use, press the green
button, which simultaneously activates the evaporator and returns the
Cin-Eliminator to its storage position.

You may log off if the green exit light is on over the evaporator . If
the red light is illuminated, one of the Cin-Eliminator requirements has
not been properly implemented. Press the "List Guy" call button on the
right of the evaporator . He will secure all facilities from his control
panel.

To use the Auto-Unsub, first undress and place all your clothes in the
clothes rack. Put on the velcro slippers located in the cabinet
immediately below. Enter the shower, taking the entire kit with you. On
the control panel to your upper right upon entering you will see a
"Shower seal" button. Press to activate. A green light will then be
illuminated immediately below. On the intensity knob, select the desired
setting. Now depress the Auto-Unsub activation lever. Bathe normally.

The Auto-Unsub will automatically go off after three minutes unless you
activate the "Manual off" override switch by flipping it up. When you
are ready to leave, press the blue "Shower seal" release button. The
door will open and you may leave. Please remove the velcro slippers and
place them in their container.

If you prefer the ultrasonic log-off mode, press the indicated blue
button. When the twin panels open, pull forward by rings A & B. The knob
to the left, just below the blue light, has three settings, low, medium
or high. For normal use, the medium setting is suggested.

After these settings have been made, you can activate the device by
switching to the "ON" position the clearly marked red switch. If during
the unsubscribing operation, you wish to change the settings, place the
"manual off" override switch in the "OFF" position. You may now make the
change and repeat the cycle. When the green exit light goes on, you may
log off and have lunch. Please close the door behind you.