Wheel stud specs and spacers.

Tom Paule tapaule@yahoo.com
Fri, 21 Feb 2003 08:40:43 -0600


I have found that I can replace the studs by tapping
them lightly into place with a hammer (deadblow
preferred) until they require more effort than tapping
will allow. Then I put a nut on them and tighten the
nut down until it draws the stud through the hub
(careful not to strip the nut).

I guess you could use a hammer to put the stud in all
the way, but I don't want to damage/bend the hub by
wailing on the stud with a hammer. A press would be
nice to use, but I don't have one (yet).

Tom