Ready to reinstall, hopefully (was Re: Shortening cure time for 3M urethane?)

[Tim Rogers]

Jason wrote:

> The 3M urethane-filled mount has been baking at 200F for a few minutes short
> of 24 hours and appears to fall only slightly short of being hard as a rock.
> I know the GA16 is a little heavier than the SR20 (iron vs aluminum block)
> but hopefully the urethane won't come shooting out of the mount as soon as I
> remove the jack.

If it does, then you managed to design and build the first aftermarket liquid
filled motor mount.
Good luck with it.

Tim Rogers
-'93 NX2000 T-top
-'91 NX2000 racer-to-be
-'75 Silverado tow vehicle