problems with clutch install

[Jay Whitely]

but when I went to adjust the clutch
> cable, I had to adjust it
> all the way down to the point where there was no
> more thread left on the end
> of the cable, and at this point it doesn't seem to
> engage correctly, or all
> the way.

***Aaron,

You will need to cut off about 1/2" from the threads
on the end of the clutch cable. They interfere with
the clutch release arm when you adjust the clutch
tight.  The clutch is not disengaging now because the
cable is not tight enough yet.

Get a hacksaw or a Dremel and have at it!  This
modification is necessary because the JWT pressure
plate moves the pivot point of the "fingers" of the
pressure plate to gain more leverage.

Good luck,

=====
Jay Whitely
Tampa, FL
1996 200SX SE-R
GTi-R motor with F-MAX kit