problems with clutch install

[Aaron K]

So we finally got my new JWT pressure plate and stock disk installed this
afternoon, but when I went to adjust the clutch cable, I had to adjust it
all the way down to the point where there was no more thread left on the end
of the cable, and at this point it doesn't seem to engage correctly, or all
the way.

Did anyone else here have this problem? I was a feeling for a minute that
the throwout bearing fell off, but with the new clips, it doesn't seem like
it would come off easily at all.

Any help is appreciated, thanks!

Aaron
(tore out clutch in hillsboro, or...)