High port to low port swap, wiring harness?

[Grover Pickering]

Based on what I read - and my extremely limited technical knowledge - this
is what the answer seems to be....

Swap should work
Some sensors may need to be swapped over if the sensor connectors don't
match (i.e. water temp)
Throttle cable may need some work/"engineering"
Looks like swapping HP cams into LP engine is a good thing.
May have some extra wire on a couple of sensors

Anyone of you smart folks have anything to add?

Grover


On Mon, Jan 9, 2012 at 12:46 PM, Jim Wright <wrightj at apple.com> wrote:

> Hey, throwing this back to the list again, has anyone done a swap this
> direction?  Any gotchas to worry about?
>
> Jim
>
> On Oct 19, 2011, at 3:44 PM, Jim Wright wrote:
>
> > Can anyone definitively answer if a high port wiring harness will work
> with a low port SR20DE swap?  I've got a '91 B13 with a blown engine, high
> port, and have a low port replacement.  Other than moving sensors and such
> over, and maybe undoing a few zip ties to free up cable slack, should this
> work?
> >
> > Most of the swaps I've come across in my reading have gone from low to
> high.
>
>
> +----------------------------------------------------------------------+
> The mailing list home page is http://www.se-r-list.org/
> To modify your subscription, go to
> http://www.se-r-list.org/mailman/listinfo/se-r
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.se-r-list.org/pipermail/se-r/attachments/20120110/f5ff0f32/attachment.html