[SML-NON-PERF] PIAA install

[Jason Gould]

I am almost finished istalling a set of PIAA's I
picked up at Costco.  But I have one barrier stopping
me.  There is one wire left to plug in.  It is off of
the harness that goes through the firewall.  I was
going to just hook it up to a Constant positive.  But,
the directions say something about a legallity of the
brights running while the Driving lights are on.

Directions:

Diagram reads - SWITCH POWER CONNECT TO POSSITIVE (+)
POWER SOURCE = WHITE

7.  Using the supplied connector, connect the switch
power wire (H) to power source.  Legal operation of
these driving lights requieres the power source be one
that is only powered (+) when the high beem of the
headlamps are on.

So, I so what wire am I supposed to crimp to?  Or
could I just tye into a accessory Positive so the
Lights would not work when the car was off?

Thank You

Jason