Axle Help

[Vinson Mok]

Remove the axle halfshaft assembly, and file or dremel down the flared ends
of the half shalf CV splines.  Taper them slightly while you're at it.  When
it was initially inserted, it was not perfectly straight.  Upon first impact
from a hammer or such, the ends of the splines on the shaft get flared out.
It will be next to impossible to get in.  At least this is the problem I had
several weeks ago!  After fixing the ends, it half shaft slide in with
minimal force to clear the second set of splines and for the snap ring to
set on the proper groove.

-V

From: se-r-admin@lists.deskmedia.com
[mailto:se-r-admin@lists.deskmedia.com]On Behalf Of Chris Kawa
Sent: Tuesday, April 16, 2002 1:15 PM
To: se-r@lists.deskmedia.com
Subject: Axle Help