bell housing seperation

Chris Kawa sr20depwr@hotmail.com
Wed, 10 Apr 2002 08:15:13 -0500


Wont this make my gears also com out?  I just need to put a new housing on.
So I dont want all the gears and little pieces flying out.

Lawrence Weeks

>Another note. The big snap ring is what secures the main shaft end
>bearing into the case. That bearing may not want to come out of the
>case when you are pulling up on it (the case). What I do is place
>some rags over the bearing and tap it with a mallet while pulling
>the case up, thus popping the bearing out of the case.