RWD SR20DET Bearing Pics Part II

[Louis Rosanova]

Well when i disassembled my spare motor, the chain was on their pretty tight
and wouldnt come off until I pulled it off. On top of that the bottom end
was on an engine stand and must of been turned ten times at least and it
still didnt fall off the lower sproket.

So im assuming it must be very difficult to skip a tooth when doing cam
install based on that motor. Though id still keep tension on the chain just
incase.

Louis Rosanova

> Jay Hassinger wrote:
 > >When doing a cam change I've heard that there is not enough room below
the
> >lower sprocket for the timing chain to "drop" off the sprocket
completely.

> Did this person have a banana in their hand when telling you this?

> I have some photos in my Beast series that will give you an idea.

> George Roffe