koni inserts

COOKIE JARANILLA Jaranc@lacera.com
Thu, 12 Jun 2003 16:22:42 -0500


The pillow ball mounts (type RS) is ordered as a set with the suspension
(either with or without).  The pillow ball camber plate set (type AP) is
special order.
http://www.tein.com/pumnt.html

...so are the tender springs and the spacer spring seat
http://www.tein.com/stsp.html.

>>> mike kojima <choaderboy2@yahoo.com> 06/12/03 02:13PM >>>
>From my examination so far, but still not having test
driven them yet, I am pretty impressed with the Tein
setup. The workmanship and detail on these parts is
fantastic.  You can lower the car a full 2" without
travel issues.  Tein can also do custom valving for
other spring rates.

I think that Teins are the best bang for the buck
solution for the B14/B15.  Only if you are a serious
racer will you need the double adjustment of GC's and
others. I will know for sure once I start driving the
suspension.

Cookie, Tein doent have PB mounts listed for the B14
are you sure you can get them?  I am using Shigspeed
custom rear and modifed GC's in the front.

Mike
--- COOKIE JARANILLA <Jaranc@lacera.com> wrote:
> Tein has pillow ball camber plates.  And one that
> fits right out of the box
> without banging up and leveling the strut perch like
> other plates out there.

> This suspension has been proven to kick ass at the
> super2ner honda/nissan
> challenge (Bob Seeckts car) at streets, running as
> backup w/ 1:38s normally
> aspirated from the turbo guys 1:36s.  This car was
> running 2 inches lower than
> stock.  Your coil binding concerns...put it to
> rest...you will not find it
> here.

__________________________________
Do you Yahoo!?
Yahoo! Calendar - Free online calendar with sync to Outlook(TM).
http://calendar.yahoo.com